Breaking News
recent

Subscribe On Youtube: Mechengg.net

What Is Comparators In metrology | Classification Of Comparators

What Is Comparators In metrology | Classification Of Comparators

Introduction/Principle Of Comparators: 
Comparators can give precision measurements, with consistent accuracy by eliminating human error. They are employed to find out, by how much the dimensions of the given component differ from that of a known datum. If the indicated difference is small, a suitable magnification device is selected to obtain the desired accuracy of measurements. It is an indirect type of instrument and used for linear measurement. If the dimension is less or greater, than the standard, then the difference will be shown on the dial. It gives only the difference between actual and standard dimension of the workpiece. To check the height of the job H2 ,with the standard job of height H1
Principle Of Comparators
Principle Of Comparators 
Initially, the comparator is adjusted to zero on its dial with a standard job in position
as shown in Figure(a). The reading H1is taken with the help of a plunger. Then the standard
job is replaced by the work-piece to be checked and the reading H2 is taken. If H1and H2 are different, then the change i~ the dimension will be shown on the dial of the comparator. Thus difference is then magnified 1000 to 3000 X to get the clear variation in the standard and actual job.

In short, Comparator is a device which
(1) Picks up small variations in dimensions.
(2) Magnifies it.
(3) Displays it by using indicating devices, by which comparison can be made with some
standard value.

Classification:
1. Mechanical Comparator: It works on gears pinions, linkages, levers, springs etc.
2. Pneumatic Comparator: Pneumatic comparator works by using high pressure air, valves, back pressure etc.
3. Optical Comparator: Optical comparator works by using lens, mirrors, light source etc.
4. Electrical Comparator: Works by using step up, step down transformers.
5. Electronic Comparator: It works by using amplifier, digital signal etc.
6. Combined Comparator: The combination of any two of the above types can give the best result.

Characteristics of Good Comparators:
1. It should be compact.
2. It should be easy to handle.
3. It should give quick response or quick result.
4. It should be reliable, while in use.
5. There should be no effects of environment on the comparator.
6. Its weight must be less.
7. It must be cheaper.
8. It must be easily available in the market.
9. It should be sensitive as per the requirement.
10. The design should be robust.
11. It should be linear in scale so that it is easy to read and get uniform response.
12. It should have less maintenance.
13. It should have hard contact point, with long life.
14. It should be free from backlash and wear.

No comments:

Post a Comment

Powered by Blogger.