Breaking News

Basic Components and its Fuctions of a Hydraulic System

Basic Components of a Hydraulic System

 Hydraulic systems are power-transmitting assemblies employing pressurized liquid as a fluid for transmitting energy from an energy-generating source to an energy-using point to accomplish useful work. Figure shows a simple circuit of a hydraulic system with basic components.

Basic Components Of Hydraulic System
Basic Components Of Hydraulic System
Functions of the components shown in Fig.  are as follows: 

1. The hydraulic actuator is a device used to convert the fluid power into mechanical power to do useful work. The actuator may be of the linear type (e.g., hydraulic cylinder) or rotary type(e.g., hydraulic motor) to provide linear or rotary motion, respectively. 

2. The hydraulic pump is used to force the fluid from the reservoir to rest of the hydraulic circuit by converting mechanical energy into hydraulic energy.

 3. Valves are used to control the direction, pressure and flow rate of a fluid flowing through the circuit. Motor 1 – Off 2 – Forward 3– Return 3 2 1 Load Direction control valve Pump Oil tank Filter Actuator Pressure regulator 

4. External power supply (motor) is required to drive the pump. 

5. Reservoir is used to hold the hydraulic liquid, usually hydraulic oil. 

6. Piping system carries the hydraulic oil from one place to another. 

7. Filters are used to remove any foreign particles so as keep the fluid system clean and efficient, as well as avoid damage to the actuator and valves. 

8. Pressure regulator regulates (i.e., maintains) the required level of pressure in the hydraulic fluid. 

The piping shown in Fig.  is of closed-loop type with fluid transferred from the storage tank to one side of the piston and returned back from the other side of the piston to the tank. Fluid is drawn from the tank by a pump that produces fluid flow at the required level of pressure. If the fluid pressure exceeds the required level, then the excess fluid returns back to the reservoir and remains there until the pressure acquires the required level. Cylinder movement is controlled by a three-position change over a control valve. 1. When the piston of the valve is changed to upper position, the pipe pressure line is connected to port A and thus the load is raised. 2. When the position of the valve is changed to lower position, the pipe pressure line is connected to port B and thus the load is lowered. 3. When the valve is at center position, it locks the fluid into the cylinder(thereby holding it in position) and dead-ends the fluid line (causing all the pump output fluid to return to tank via the pressure relief). 

No comments:

Post a Comment

Powered by Blogger.