Breaking News
recent

Fabrication of Automatic Drilling and Reaming Attachment Control

Fabrication of Automatic Drilling and Reaming Attachment Control

OBJECTIVE;
  • To develop industrial automation and assist  with CIM environment.
  • To promote the unmanned industry.
  • To promote the unmanned industry.
Project Background;
In the present global rationalization and competitive world most of the industries set up unmanned industry in order to eliminate labour cost and  to increase productivity.

SYNOPSIS;

      The main aim of this project is to acquire practical Knowledge in the field of automation using PLC.( Programming Logic Controller ).In this project “FABRICATION OF AUTOMATIC DRILLING AND REAMING ATTACHMENT ” the job is feeded, drilled and reamed automatically. 

Initially the job is loaded manually. The job , drilling, reaming feed movements done by the  separate DC motors through the lead screw and nut mechanism .These motors are controlled by the PLC- Programmable Logic Controller . 

These movements are stopped at particular position using magnetic sensors which sends the signal to the input of PLC .The entire operation is done automatically by using PLC, the components are manufactured with less time and the production rates are increased.

Fabrication of Automatic Drilling and Reaming Attachment Control
Block Diagram of  Fabrication of Automatic Drilling and Reaming Attachment Control

Project Elements
Controller
Power Supply
Drilling mahine( 2 nos)
DC Motor ( 3nos)
Forward and reverse control relay  6 nos
vice
Screw rod mechanism ( 2 set)

Advantages;
This system is used to develop industrial automation and assist  with CIM environment.
It  promote the unmanned industry.
Reduces waste motions which cause fatigues to worker.
It reduces labour cost.

No comments:

Post a Comment

Powered by Blogger.